Headlamp Aiming Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Open the hood.
- Measure from the floor to the center of the headlamp bulb.
- At the screen, measure from the floor and place the horizontal tape at the measured distance.
- Measure from the reference line on the floor to the left headlamp bulb centerline.
- At the screen, measure from the reference line and place the vertical tape at the measured distance.
- Measure from the reference line on the floor to the right headlamp bulb centerline.
- At the screen, measure from the reference line and place the vertical tape at the measured distance.
- Turn ON the low beam headlamps and block the light from projecting onto the screen from the passenger side headlamp.
- Adjust the screw (4) for the vertical aim of the headlamps to the specifications required by the state and the local authorities.
- Rotate the headlamp adjuster to change the vertical aim of the headlamp.
- Repeat the aiming procedure for the passenger side headlamp while blocking the light from projecting onto the screen from the driver side headlamp.
- Turn the headlamps OFF.
- Close the hood.
IMPORTANT:
Do not cover the headlamp. This may cause excessive heat build up. Use a piece of cardboard forward of the headlamp to block the light.