LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Lighting Systems) >> Repair Instructions >> Door Jamb Switch Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Door Jamb Switch
    GM315272Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Always use a new sliding door jamb switch. Do not reuse or try to adjust a used switch.
    • When a new sliding door jamb switch is installed and the sliding door is closed for the first time, the plunger is forced into the sleeve and automatically adjusts the sliding door jamb switch for the sliding door.
  1. Open the sliding door screw from the sliding door jamb switch bracket.
  2. Remove the sliding door jamb switch from the pillar.
  3. Disconnect the electrical connector from the sliding door jamb switch.
scientia non olet · About LEMON Manuals