LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Lighting Systems) >> Diagnostic Information and Procedures >> Vanity Mirror Lamp(s) Inoperative

Vanity Mirror Lamp(s) Inoperative

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Vanity Mirror Lamp(s) Inoperative

Step Action Yes No
Schematic Reference: Interior Lights Schematics 
Connector End View Reference: Master Electrical Component List in Wiring Systems
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Open the vanity mirror cover.
  2. Close the vanity mirror cover.
Do the vanity mirror lamps operate properly?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Are all vanity mirror and reading lamps inoperative? Go to Reading Lamp(s) Inoperative  Go to Step 4 
4 Check the bulb of the inoperative lamp. Refer to Vanity Mirror Lamp Replacement .
Is the bulb OK?
Go to Step 5  Go to Step 7 
5 Test the inadvertent power courtesy lamp and ground circuits of the sunshade for high resistance or an open. Refer to Circuit Testing andWiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 6 
6 Inspect for poor connections at the harness connector of the inoperative vanity mirror lamp assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
7 Replace the bulb.
Did you complete the replacement?
Go to Step 9  -
8 Replace the sunshade. Refer to Sunshade Replacement in Interior Trim.
Did you complete the replacement?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2