Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Position the horn (2) to the front impact bar.
- Install the horn bracket bolt (1).
Tighten: Tighten the bolt to 15 N.m (11 lb ft).
- Connect the horn electrical connector.
- Install the headlamps. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting Systems.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.