Test Description
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 8: Tests if ground is constantly being applied to the horn relay.
- 10: The horn relay control circuit includes the horn slip ring and the horn switch. The horn switch is part of the inflatable restraint steering wheel module. The horn slip ring and the horn switch must be tested for a short to ground.
Horns Always On
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Is the vehicle equipped with content theft deterrent (UA6)? | Go to Step 2 | Go to Step 3 |
| 2 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 4 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 3 | Did you review the horns operation and perform the necessary inspections? | Go to Step 4 | Go to Symptoms - Horns |
| 4 | Depress and release the horn switch. Is the horn on at all times? |
Go to Step 5 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 5 | Is the vehicle equipped with theft deterrent (UA6)? | Go to Step 6 | Go to Step 7 |
| 6 | Disconnect the body control module (BCM). Is the horn on at all times? |
Go to Step 7 | Go to Step 11 |
| 7 | Disconnect the horn relay. Is the horn on at all times? |
Go to Step 12 | Go to Step 8 |
| 8 | Connect a test lamp between the battery positive voltage circuit of the horn relay coil and the horn relay control circuit. Does the test lamp illuminate? |
Go to Step 10 | Go to Step 9 |
| 9 | Inspect for poor connections at the horn relay. Refer to Testing for Intermittent Conditions and Poor Connections
andConnector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 15 | Go to Step 14 |
| 10 |
IMPORTANT:
The horn switch is part of the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement
in SIR.
|
Go to Step 15 | - |
| 11 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 15 | Go to Step 13 |
| 12 | Repair the short to voltage in the horn control circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 15 | - |
| 13 | Replace the BCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement? |
Go to Step 15 | - |
| 14 | Replace the horn relay. Did you complete the replacement? |
Go to Step 15 | - |
| 15 | Operate the horn. Does the horn operate properly? |
System OK | Go to Step 1 |