LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Computer/Integrating Systems) >> Description and Operation >> Data Link Communications Description and Operation >> Data Link Connector (DLC)

Data Link Connector (DLC)

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The data link connector (DLC) is a standardized 16-way connector located below the instrument panel and close to the steering column. Both the connector design and location are dictated by industry wide agreement to follow SAE J1962 standards.

All DLCs are required to provide a power supply, hot at all times, to Pin 16. This circuit is used to power the scan tool. All DLCs provide a power ground at Pin 4 and a clean signal ground at Pin 5.

The class 2 serial data communications circuit is provided at Pin 2 of the DLC.

scientia non olet · About LEMON Manuals