Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Open and support the hood.
Disconnect the negative battery cable. Refer to BATTERY DISCONNECT CAUTION .

Fig 1: Removing/Installing Covers

GM1506794

Courtesy of GENERAL MOTORS CORP.

Remove the cover (1) from the base (6) of the accessory wiring junction block assembly.

Fig 2: Removing/Installing Battery Cable

GM1506811

Courtesy of GENERAL MOTORS CORP.

Remove the positive battery cable nut (3) and disconnect the cable (2) from the positive terminal stud.

Fig 3: Inspecting Outer Locking Tabs

GM1536795

Courtesy of GENERAL MOTORS CORP.

Release the 2 locking tabs from the base side as indicated by the arrows of the electrical center (1), as shown.

Fig 4: Removing/Installing Underhood Accessory Wiring Junction Block Assembly

GM1536796

Courtesy of GENERAL MOTORS CORP.

Carefully lift at each side of the underhood accessory wiring junction block assembly in order to release the underhood accessory wiring junction block assembly from the 3 main body harness connectors (1) and exposing the lower connectors.
Remove the underhood accessory wiring junction block assembly from the vehicle.

Fig 5: Restaging Harness Connectors

GM1536798

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Using a hook-type tool, as shown, re-stage all 3 lower harness connectors into the lower base prior to installing the new underhood accessory wiring junction block assembly.

Use the hook tool to pull the connector (1) upward in order to secure the connectors into the base.