Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Locate the relay. Refer to the Master Electrical Component List to locate the relay in the vehicle.
- Remove any fasteners which hold the relay in place.
- Remove any connector position assurance (CPA) devices or secondary locks.
- Separate the relay (1) from the wire harness connector (2).
IMPORTANT:
Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.