LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Wiring Systems - Testing, Diagnosis & Repair) >> Diagnostic Information and Procedures >> Delphi Connectors (Pull To Seat) >> Terminal Installation

Terminal Installation

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
  2. If necessary, cut the new wire to proper length and splice with existing circuit. Refer to Splicing Copper Wire Using Splice Sleeves .
  3. If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
  4. Install the TPA, CPA, and/or the secondary locks.
scientia non olet · About LEMON Manuals