LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Wiring Systems - Testing, Diagnosis & Repair) >> Diagnostic Information and Procedures >> Bosch Connectors (0.64) >> Terminal Replacement Procedure

Terminal Replacement Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Never insert the same terminal back into the connector once it is removed. Crimp on a new terminal.
    2. Fig 1: Aligning Coding Lugs With Connector Coding Grooves
    GM1442741Courtesy of GENERAL MOTORS CORP.
  2. Prior to installation the terminal must be aligned so the (1) coding lugs align with the (2) coding grooves on the connector.
  3. Once the terminal is aligned, slide the terminal into the cavity until the retainer has engaged in the cavity of the connector.
  4. Slide the TPA in the connector body and seat it using a small flat bladed tool. The TPA is seated when it is flush with the contact housing.
  5. Secure the wires to the connector body using a tie wrap and replace the dress cover and grommet.
scientia non olet · About LEMON Manuals