LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> Air Bag Indicator Circuit Malfunction >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

If battery voltage is outside of the normal operating voltage range, 9-16 volts, the AIR BAG warning indicator will come ON solid with no DTCs set. For more detailed information concerning the Class 2 data lines, refer to Data Link Communications Description and Operation in Computer/Integrating Systems.

The following are possible causes of the malfunction:

Air Bag Indicator Circuit Malfunction

Step Action Value(s) Yes No
Schematic Reference: SIR Schematics 
Connector End View Reference: SIR Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Using a scan tool establish communication with the inflatable restraint sensing and diagnostic module (SDM).
  2. Use the scan tool to request the SIR data list display.
  3. With a scan tool, observe the ignition voltage parameter in the SIR data list.
Does the scan tool indicate that the ignition voltage is within the specified range?
9-16 V Go to Step 3  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
3
  1. Using the scan tool pull up Special Functions in Instrument Panel Cluster.
  2. Go to Display(s) Test for Instrument Cluster in Output Control.
  3. In the Display Test mode you can turn ON or OFF the instrument panel indicators.
  4. All indicators will turn ON when commanded on.
Does scan tool command the AIR BAG Warning Indicator ON then OFF?
- Go to Step 4  Go to Step 5 
4 Replace the SDM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?
- Go to Diagnostic System Check - Vehicle in Vehicle DTC Information -
5 The AIR BAG warning indicator is not serviceable separately. The instrument panel cluster (IPC) must be serviced/replaced as a complete unit. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the repair?
- Go to Diagnostic System Check - Vehicle in Vehicle DTC Information -