LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Cellular Communication Systems) >> Repair Instructions >> Coaxial Cable Replacement - Cellular Telephone >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel (I/P) trim pad. Refer to Upper Trim Pad, Outer Trim Cover, Fuse Block Access Cover Replacement - Instrument Panel in Instrument Panel, Gages and Console.
    2. Fig 1: View Of Cellular Antenna Coaxial Cable
    GM661374Courtesy of GENERAL MOTORS CORP.
  2. Remove the garnish molding from the right side windshield pillar.
  3. Unscrew the coaxial cable from the cellular antenna on the windshield.
  4. Unscrew the coaxial cable from the VIU/VCU module.
    5. Fig 2: Locating Bolt On Ground Tab
    GM661371Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt from the ground tab on the right side on the I/P.
    6. Fig 3: Locating Cable Clips
    GM661370Courtesy of GENERAL MOTORS CORP.
  6. Remove the cable clips which secure the cable to the I/P.
    7. Fig 4: Locating Coaxial Cable
    GM661372Courtesy of GENERAL MOTORS CORP.
  7. Remove the coaxial cable.
scientia non olet · About LEMON Manuals