Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Coaxial Cable

Courtesy of GENERAL MOTORS CORP.

Install the coaxial cable.

Fig 2: Locating Cable Clips

Courtesy of GENERAL MOTORS CORP.

Install the cable clips to the I/P frame.

Fig 3: Locating Bolt On Ground Tab

Courtesy of GENERAL MOTORS CORP.

Install the bolt to the ground tab on the right side on the I/P.

Fig 4: View Of Cellular Antenna Coaxial Cable

Courtesy of GENERAL MOTORS CORP.

Install and tighten the coaxial cable to the VIU/VCU module.
Retape the cable to the A-pillar.
Install and tighten the coaxial cable to the cellular antenna on the windshield.
Install the garnish molding to the right side windshield pillar.
Install the I/P trim pad. Refer to Upper Trim Pad, Outer Trim Cover, Fuse Block Access Cover Replacement - Instrument Panel in Instrument Panel, Gages and Console.