Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the blower motor.
- Install the blower motor screws.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Connect the blower motor electrical connector.
- Install the right side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.