LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the blower control module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 new screws in the pre-drilled holes to the side of the heat stakes in the blower control module and the HVAC module assembly.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

    3. Fig 1: Disconnecting/Connecting Blower Control Module Electrical Connector
    GM1262636Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the blower control module.
  4. Install the right side I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals