Conditions for Running the DTC

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

DTCs P0030, P0053, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0125 where applicable, P0128, P0131, P0132, P0133, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P1133 and P1134, P2135 are not set.
Where applicable, DTCs P0412, P2440, P2444 are not set.
The Engine Run Time parameter is at least 3 minutes.
The traction control, if equipped, is not active.
The PCM is not commanding Power Enrichment or Decel Fuel Cutoff modes.
The MAF Sensor parameter is between 5-38 g/s.
The Engine Speed parameter is between 602-3,000 RPM.
The TP Indicated Angle parameter is between 3-35 percent.
The ECT Sensor parameter is more than 65°C (149°F).
The system voltage is between 9-18 volts.
The above conditions have been met for 3 seconds.