Conditions for Running the DTC

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

DTCs P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0120, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0300, P0401, P0403, P0404, P0405, P0406, P0420, P0442, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0462, P0463, P0464, P0496, P0506, P0507, P1133, P1134, P1404, P1516, P2101, P2107, P2108, P2119, P2120, P2125, P2135, P2138, P2A00, P2A01 are not set.
The engine is in Closed Loop status.
Fuel Trim Learn is enabled.
The engine coolant is between 38.5-121°C (101.3-250°F).
The intake air temperature (IAT) is between -38.5 and +140°C (-37.3 and +284°F).
The manifold absolute pressure (MAP) is between 15-99 kPa (2.1-28.8 psi).
The vehicle speed is less than 132 km/h (82 mph).
The engine speed is between 525-5,600 RPM.
The barometric pressure (BARO) is more than 70 kPa (10.1 psi).
The idle purge is enabled.
The mass air flow (MAF) is between 1-150 g/s.
The fuel level is more than 10 percent.
The scan tool special functions are not active.