Conditions for Running the DTC
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
The following conditions must be met:
- DTCs P0030, P0053, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0125 (where applicable), P0128, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P2135 are not set.
- DTCs P2A01, P0401, P0420 are not commanding fuel.
- The system voltage is between 9-18 volts.
- The scan tool special functions are not active.
- The Engine Run Time parameter is more than 100 seconds.
- The ECT Sensor parameter is at least 65°C (149°F).
- The MAF sensor parameter is between 4-30 g/s.
- The Engine Speed parameter is between 600-3,000 RPM.
- The above conditions have been met for at least 2 seconds.