LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Removing/Installing Brake Caliper & Rotor
    GM156924Courtesy of GENERAL MOTORS CORP.
  3. Remove the brake caliper and bracket. Refer to Brake Caliper Bracket Replacement - Rear (J65, JL9) in Disc Brakes.
  4. Remove the rotor (3). Refer to Brake Rotor Replacement - Rear (J65, JL9) in Disc Brakes.
  5. Use the J 6627-A  (2) to extract the wheel hub bolt from the hub (1).
  6. Clean the wheel hub flange and clean the rotor of any corrosion, metal chips or foreign material.
scientia non olet · About LEMON Manuals