LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheel Stud
    GM65317Courtesy of GENERAL MOTORS CORP.
  1. Install the replacement bolt (3) in the wheel hub.
  2. Add enough washers (1) to draw the bolt into the hub.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT: Seat the wheel bolt fully against the hub flange.
  3. Install the wheel nut (2) with the flat side to the washers.

    Tighten:  Tighten the wheel nut until the wheel bolt head seats against the hub flange.

  4. Back off the wheel nut.
  5. Remove the washers.
  6. Install the rotor. Refer to Brake Rotor Replacement - Rear (J65, JL9) in Disc Brakes.
  7. Install the brake caliper and bracket. Refer to Brake Caliper Bracket Replacement - Rear (J65, JL9) in Disc Brakes.
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals