LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Clamp Bolts & Stabilizer Shaft
    GM1209600Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft to the rear suspension support.
  2. Install the stabilizer shaft clamps and bolts. Do not tighten the bolts at this time.
    3. Fig 2: View Of Stabilizer Shaft Link
    GM614968Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the right and left stabilizer shaft link nuts (1) to the stabilizer shaft links (2).

    Tighten: 

    • Tighten the stabilizer shaft link nuts to 45 N.m (33 lb ft).
    • Tighten the stabilizer shaft insulator bracket nuts to 51 N.m (38 lb ft).

  4. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals