LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Parking Brake System) >> Repair Instructions >> Park Brake Warning Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Parking Brake Indicator Switch
    GM177084Courtesy of GENERAL MOTORS CORP.
  1. Install the parking brake indicator switch (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting screw.

    Tighten:  Tighten the mounting screw to 3 N.m (26 lb in).

  3. Connect the electrical connector to the switch.

    Check the operation of the switch.

  4. Install the left carpet retainers. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  5. Install the left side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals