LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front cable into the vehicle as noted in the removal procedure.
  2. Install the front park brake cable into the bracket on the park brake assembly.
    3. Fig 1: View Of Retaining Clip
    GM648107Courtesy of GENERAL MOTORS CORP.
  3. Insert the cable button end into the clevis and install the retaining clip.
  4. Reposition the carpeting properly.
  5. Install the left side carpet retainers and the lower center pillar panel on the left side. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  6. Install the left side closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  8. Install the front park brake cable through the park brake cable guides.
  9. Install the front park brake cable into the equalizer.
    10. Fig 2: View Of Front Brake Cable Connected To Right Rear Cable
    GM717002Courtesy of GENERAL MOTORS CORP.
  10. Connect the front park brake cable (1) to the rear cable (3) at the connector clip (2).
    11. Fig 3: View Of Parking Brake Adjustment
    GM177170Courtesy of GENERAL MOTORS CORP.
  11. Tighten the nut on the equalizer (2) in order to remove slack in the cable.
  12. Lower the vehicle.
  13. Adjust the park brake system. Refer to Park Brake Adjustment (L26 and L32) .
scientia non olet · About LEMON Manuals