LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear seat belt retractor in the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Be sure to seat the alignment tabs.
    Fig 1: Locating Rear Seat Belt Retractor Bolt
    GM157291Courtesy of GENERAL MOTORS CORP.
  2. Install the rear seat belt retractor bolt.

    Tighten:  Tighten the rear seat belt retractor bolt to 68 N.m (50 lb ft).

  3. If installing the center retractor, pass the seat belt through the bezel opening and install the belt bezel.
  4. Return the rear sound barrier to its installed position. Refer to Sound Barrier Replacement - Rear Seat Back in Interior Trim.
    5. Fig 2: View Of Retractor Anchor Bolt At Floorpan
    GM371958Courtesy of GENERAL MOTORS CORP.
  5. Install the rear seat belt retractor anchor bolt to the floorpan.

    Tighten:  Tighten the rear seat belt retractor bolt to 42 N.m (31 lb ft).

  6. Install the rear window trim panel to its installed position. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
scientia non olet · About LEMON Manuals