Seat Cushion Cover Replacement - Front

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Cushion - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Preliminary Procedures Remove the front bucket seat. Refer to Seat Replacement - Front Bucket . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Rezeroing Procedure .
1	Handle, Seat Recliner Refer to Seat Back Recliner Handle Replacement - Front .
2	Cover, Seat Adjuster Finish Cover Refer to Seat Adjuster Track Cover Replacement - Front .
3	Cover, Seat Cushion Tip: Disconnect the seat cover J-channel from the seat cushion frame.