LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front (Two-Way Manual) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the front seat trim panel. Refer to Seat Adjuster Track Cover Replacement - Front .
    3. Fig 1: Seat Belt Bracket & Bolt
    GM802619Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The bracket is NOT included with a seat adjuster. Reinstall the existing bracket.
  3. Remove the seat belt bracket (2) on the door side of the seat.
  4. Remove the seat belt pretensioner. Refer to Seat Belt Buckle Pretensioner Replacement in SIR.
    5. Fig 2: Front Seat Pan Bolts
    GM865020Courtesy of GENERAL MOTORS CORP.
  5. Remove the seat trim and the pad. Refer to Seat Cushion Replacement - Front .
  6. Remove the 4 seat frame bolts.
  7. Remove the seat frame
    8. Fig 3: Adjuster Cover Plates
    GM864992Courtesy of GENERAL MOTORS CORP.
  8. Remove the 2 adjuster cover plates.
    9. Fig 4: Front Seat Back Frame Bolts
    GM865006Courtesy of GENERAL MOTORS CORP.
  9. Remove the seat back frame bolts.
  10. Remove the seat back from the adjuster.
    11. Fig 5: Adjuster, Seat Cushion Frame & Crossbrace Bolts
    GM310454Courtesy of GENERAL MOTORS CORP.
  11. Remove the adjuster from the seat cushion frame.
  12. Remove the adjuster crosswire and assist springs.
  13. Remove the crossbrace bolts in order to separate the left and the right adjusters.
scientia non olet · About LEMON Manuals