LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Wheel Alignment System) >> Repair Instructions >> Rear Camber Adjustment >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Camber Adjustment
    GM156938Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle and provide suitable support. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the strut from the vehicle. Refer to Strut Assembly Replacement in Rear Suspension.
  4. Place the strut in a vise and file the upper strut-to-knuckle hole lateral (oblong). Compare the appearance of the holes before filing (2) with after filing (3).
scientia non olet · About LEMON Manuals