Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Camber Adjustment

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the strut to the vehicle. Refer to Strut Assembly Replacement in Rear Suspension.
Tighten: Tighten the strut-to-knuckle nuts as far as to allow movement of the knuckle.
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Adjust the camber (1).
Tighten: Tighten the strut-to-knuckle nuts to 120 N.m (89 lb ft).
Lower the vehicle.