LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Torque Converter Covers
    GM631009Courtesy of GENERAL MOTORS CORP.
  1. Install the torque converter covers.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the torque converter cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals