LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Brace Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transaxle Brace & Bolts
    GM160962Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle brace.
  2. Hand start the bolts to the engine and to the transaxle.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the transaxle brace bolts to the transaxle.

    Tighten:  Tighten the transaxle brace bolts to the transaxle to 43 N.m (32 lb ft).

  4. Install the transaxle brace bolts to the engine.

    Tighten:  Tighten the transaxle brace bolts to the engine to 63 N.m (46 lb ft).

  5. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals