LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Accumulator and 2-1 Manual Servo Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manual 2-1 Band Servo
    GM164811Courtesy of GENERAL MOTORS CORP.
  1. Install the manual 2-1 band servo (106-116).
    2. Fig 2: View Of Accumulator Assembly
    GM97365Courtesy of GENERAL MOTORS CORP.
  2. Install the accumulator assembly.
    3. Fig 3: Identifying Accumulator & Manual 2-1 Band Servo Cover Bolts
    GM164809Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the manual 2-1 band servo cover bolts (103).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Install the accumulator cover bolts (131).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  5. Install the filter. Refer to Oil Filter and Seal Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals