LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Link
    GM357456Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer link into the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the stabilizer shaft link bolt and nut.

    Tighten:  Tighten the stabilizer shaft link nut to 23 N.m (17 lb ft).

  3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals