LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Replacing Valve Rocker Arm and Push Rod >> Installation

Replacing Valve Rocker Arm and Push Rod: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use compressed air in order to blow oil out of the tapped holes in the cylinder head.
    2. Fig 1: Push Rods
    GM406030Courtesy of GENERAL MOTORS CORP.
  2. Lubricate the ends of the push rods with new engine oil.
  3. Install the push rods to the same position on the cylinder head.
    4. Fig 2: Push Rod Guide Plates
    GM406028Courtesy of GENERAL MOTORS CORP.
  4. Install the push rod guide plates.
    5. Fig 3: Rocker Arm & Bolts
    GM406027Courtesy of GENERAL MOTORS CORP.
  5. Install the valve rocker arms.
    6. NOTE: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.
  6. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the rocker arm bolt threads.
    7. NOTE: Refer to Fastener Notice in General Information.
  7. Install the valve rocker arm bolts.

    Tighten: 

    1. Tighten the bolts to 15 N.m (11 Ft. Lbs.).
    2. Use the J 45059  to rotate the bolts an additional 90 degrees.

  8. Install the left or the right valve rocker arm cover. Refer to Replacing Valve Rocker Arm Cover - Left  or Replacing Valve Rocker Arm Cover - Right .
  9. Inspect the valve train for noise.
scientia non olet · About LEMON Manuals