LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Replacing Right Engine Mount Strut >> Installation

Replacing Right Engine Mount Strut: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount Strut
    GM97613Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut.
    2. NOTE: Refer to Fastener Notice in General Information.
  2. Install the bolt and the nut to the right engine mount strut at the right engine mount strut bracket on the upper radiator support.

    Tighten:  Tighten the engine mount strut bolt to 48 N.m (35 Ft. Lbs.).

    3. Fig 2: Right Engine Mount Strut Bolt & Nut (L26)
    GM1210280Courtesy of GENERAL MOTORS CORP.
  3. With a L26 Engine, install the bolt and the nut to the right engine mount strut at the right engine mount strut bracket on the engine.

    Tighten:  Tighten the engine mount strut nut to 48 N.m (35 Ft. Lbs.).

    4. Fig 3: Right Engine Mount Strut Bolt & Nut (L32)
    GM1210282Courtesy of GENERAL MOTORS CORP.
  4. With a L32 Engine, install the bolt and the nut to the right engine mount strut at the right engine mount strut bracket on the engine.

    Tighten:  Tighten the engine mount strut nut to 48 N.m (35 Ft. Lbs.).

scientia non olet · About LEMON Manuals