Replacing Right Engine Mount Strut Bracket (L26): Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Upper Engine Mount Strut Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the upper engine mount strut bracket.

NOTE: Refer to Fastener Notice in General Information.

Install the upper engine mount strut bracket bolts.
Tighten: Tighten the bolts to 50 N.m (37 Ft. Lbs.).

Fig 2: View Of Lower Engine Mount Bracket

Courtesy of GENERAL MOTORS CORP.

Install the lower engine mount strut bracket bolts.
- Tighten the lower engine mount strut bracket nut.
  Tighten: Tighten the nut to 30 N.m (22 Ft. Lbs.).
- Tighten the lower engine mount strut bracket bolts.
  Tighten: Tighten the bolts to 50 N.m (37 Ft. Lbs.).

Fig 3: Right Engine Mount Strut Bolt & Nut (L26)

Courtesy of GENERAL MOTORS CORP.

Install the right engine mount strut at the upper engine mount strut bracket. Refer to Replacing Engine Mount Strut - Left and Replacing Engine Mount Strut - Right .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26) in Engine Electrical.