LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Replacing Left Engine Mount Strut Bracket >> Installation

Replacing Left Engine Mount Strut Bracket: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Engine Mount Strut Bracket & Bolts
    GM35814Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut bracket to the head.
    2. NOTE: Refer to Fastener Notice in General Information.
  2. Install the engine mount strut bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 Ft. Lbs.).

    3. Fig 2: Left Engine Mount Strut Bolt & Nut
    GM327466Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount strut to the left engine mount strut bracket. Refer to Replacing Engine Mount Strut - Left  and Replacing Engine Mount Strut - Right .
  4. Install the engine coolant temperature sensor. Refer to Engine Coolant Temperature (ECT) Sensor Replacement in Engine Controls - 3.8L (L26 and L32).
  5. Fill the cooling system with engine coolant. Refer to Draining and Filling Cooling System (L26 Static Fill) or Draining and Filling Cooling System (L26, LY7, GE 47716 Fill) in Engine Cooling.
scientia non olet · About LEMON Manuals