LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Replacing Front Engine Mount Bracket >> Removal

Replacing Front Engine Mount Bracket: Removal

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Refer to Transmission Replacement in Automatic Transaxle - 4T65-E.
  2. Remove the drive belt. Refer to Replacing Drive Belt (L26) .
    3. IMPORTANT: Do not discharge the air conditioning system.
  3. Remove the A/C compressor from the engine. Refer to Compressor Replacement (L26) in Heating, Ventilation, and Air Conditioning.
  4. Secure the compressor away from the bracket area.
  5. Remove the engine mount. Refer to Replacing Engine Mount - Front .
  6. Remove the engine knock sensor shield and disconnect the sensor harness. Refer to Knock Sensor (KS) 2 Replacement in Engine Controls - 3.8L (L26 and L32).
    7. Fig 1: Left Engine Mount Bracket Bolts
    GM97800Courtesy of GENERAL MOTORS CORP.
  7. Remove the front engine mount bracket bolts from the engine.
    8. Fig 2: Right Engine Mount Bracket Bolts
    GM97804Courtesy of GENERAL MOTORS CORP.
  8. Remove the rear engine mount bracket bolts from the engine.
  9. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals