LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Replacing Engine Flywheel >> Removal

Replacing Engine Flywheel: Removal

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transaxle. Refer to Transmission Replacement in Automatic Transaxle - 4T65-E.
    2. Fig 1: Holding Flywheel
    GM309963Courtesy of GENERAL MOTORS CORP.
  2. Use the J 37096  to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .
    3. Fig 2: View Of Engine Flywheel & Bolts
    GM153602Courtesy of GENERAL MOTORS CORP.
  3. Loosen the 8 engine flywheel bolts.
  4. Remove 7 of the 8 engine flywheel bolts, leaving one bolt at the top of the crankshaft rotation.
  5. Firmly grasp the engine flywheel and remove the remaining bolt. Do not drop the engine flywheel when removing the final bolt.
  6. Remove the engine flywheel.
scientia non olet · About LEMON Manuals