LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Replacing Drive Belt Idler Pulley Bracket >> Installation

Replacing Drive Belt Idler Pulley Bracket: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Idler Pulley Bracket & Bolts
    GM327162Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley bracket.
    2. NOTE: Refer to Fastener Notice in General Information.
  2. Install the idler pulley bracket bolts.

    Tighten:  Tighten the bolts to 30 N.m (22 Ft. Lbs.).

    3. Fig 2: Identifying Drive Belt Idler Pulley - Lower
    GM327164Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt idler pulley.
  4. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 Ft. Lbs.).

    5. Fig 3: View Of Supercharger Drive Belt
    GM327021Courtesy of GENERAL MOTORS CORP.
  5. Install the supercharger drive belt. Refer to Replacing Drive Belt (L26) .
scientia non olet · About LEMON Manuals