LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Removing Crankshaft Rear Oil Seal & Housing (Second Design)

Removing Crankshaft Rear Oil Seal & Housing (Second Design)

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Rear Oil Seal & Housing (Second Design)
    GM1646929Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft rear oil seal housing bolts.
  2. Remove the crankshaft rear oil seal housing and gasket.
    3. Fig 2: Removing Crankshaft Rear Oil Seal From Housing
    GM1437945Courtesy of GENERAL MOTORS CORP.
  3. Place the crankshaft rear oil seal housing face down on a clean surface and support with blocks of wood.
  4. Use a suitable driving tool and hammer and lightly tap around the outer edge of the seal to remove it.
scientia non olet · About LEMON Manuals