LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Installing Water Pump >> Installation

Installing Water Pump: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Water Pump & Components
    GM187022Courtesy of GENERAL MOTORS CORP.
  1. Install the water pump gasket.
  2. Install the water pump.
  3. NOTE: Refer to Fastener Notice in General Information.
  4. Install the water pump bolts.

    Tighten: 

    • Tighten the small water pump bolts to 22 N.m (16 Ft. Lbs.).
    • Tighten the large water pump bolts to 34 N.m (25 Ft. Lbs.).

  5. Fig 2: Identifying Water Pump Pulley Bolts
    GM36596Courtesy of GENERAL MOTORS CORP.
  6. Install the water pump pulley.
  7. Install the water pump pulley bolts.

    Tighten:  Tighten the water pump pulley bolts to 13 N.m (116 lb in).