LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Installing Valve Rocker Arm & Push Rod >> Installation

Installing Valve Rocker Arm & Push Rod: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Rocker Arm, Bolt, Push Rod & Push Rod Guide Plate
    GM35840Courtesy of GENERAL MOTORS CORP.
  1. Install the pushrod guide plate.
  2. Install the push rods.
  3. Install the valve rocker arm bearing retainer.
  4. Coat the valve stem tip and pushrod tip with prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
  5. Install the valve rocker arms.
  6. Apply GM P/N 12345493 (Canadian P/N 10953488) threadlocker or the equivalent to the valve rocker arm bolt threads.
    7. NOTE: Refer to Fastener Notice in General Information.
  7. Install the valve rocker arm bolts.

    Tighten:  Tighten the valve rocker arm bolts to 15 N.m (11 Ft. Lbs.) + 90 degrees using J 45059  .

scientia non olet · About LEMON Manuals