LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Installing Drive Belt Idler Pulley >> Installation

Installing Drive Belt Idler Pulley: Installation

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Idler Pulley & Bolt
    GM192754Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley.
    2. NOTE: Refer to Fastener Notice in General Information.
  2. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 Ft. Lbs.).

scientia non olet · About LEMON Manuals