LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Instrument Panel System Displays, Gauges And Console) >> Diagnostic Information and Procedures >> Low Engine Oil Level Indicator Inoperative

Low Engine Oil Level Indicator Inoperative

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Low Engine Oil Level Indicator Inoperative

Step Action Yes No
Schematic Reference:  Instrument Cluster Schematics  
Connector End View Reference: Engine Control Module (ECM) Connector End Views for the 3.6L engine or Powertrain Control Module (PCM) Connector End Views for the 3.8L engine
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn ON the ignition.
  2. With the scan tool, observe the Engine Oil Level Switch parameter in the ECM/PCM Data List or the IPC ECM/PCM Data Lists.
Does the Engine Oil Level Switch parameter display OK?		 Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3 Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 4  -
4 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals