Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- The DTC will become history when a power cycle has been performed and the fault is not detected by the IPC.
- The history DTC clears after 100 fault-free ignition cycles.
- The DIC receives the clear code command from the scan tool.
DTC B0933
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics or Driver Information System Schematics | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Step 4 | Go to Step 3 |
| 3 |
|
Go to Step 5 | Go to Step 6 |
| 4 | Test the compass sensor circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 5 |
| 5 | Test the compass sensor return circuit for an open, for a short to ground or for a high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 8 |
| 6 | Test the compass ignition 1 signal circuit for an open or for a high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 7 |
| 7 | Test the compass ground circuit for an open or for a high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 9 |
| 8 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 10 |
| 9 | Inspect for poor connections at the harness connector of the electronic compass module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 11 |
| 10 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 12 | - |
| 11 | Replace the electronic compass module. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 12 | - |
| 12 |
|
Go to Step 2 | System OK |