LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  3. Install a jackstand under the center of the frame, between the front frame insulators.
    4. Fig 1: View Of Front Frame Bolts & Retainers
    GM319188Courtesy of GENERAL MOTORS CORP.
  4. Remove the front frame bolts and retainers.
  5. Lower the front of the frame.
  6. Remove the frame front upper insulators.
    7. Fig 2: View Of Frame Front Upper Insulators
    GM777204Courtesy of GENERAL MOTORS CORP.
  7. Install the J 45296  , or equivalent to the front frame insulator that you are removing. See Special Tools .
  8. Using the J 45296  , or equivalent remove the front insulator from the frame. See Special Tools .
scientia non olet · About LEMON Manuals