LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement (L26) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Starter Motor & Bolts (3.8L)
    GM461901Courtesy of GENERAL MOTORS CORP.
  1. Align the starter motor to the engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the starter bolts (1, 2) finger tight until seated.

    Tighten:  Tighten the starter bolts to 43 N.m (32 lb ft).

    3. Fig 2: View Of Engine Electrical Connectors (Left Side)
    GM911140Courtesy of GENERAL MOTORS CORP.
  3. Install the positive battery cable (3) and the solenoid BAT terminal nut (2). Tighten finger tight to the starter motor.
  4. Install the starter solenoid wire (8) and the starter solenoid S terminal nut (9). Tighten finger tight to the starter motor.

    Tighten: 

    1. Tighten the solenoid BAT terminal nut (2) to 9.5 N.m (84 lb in).
    2. Tighten the starter solenoid S terminal nut (9) to 2.3 N.m (20 lb in).

  5. Install the torque converter covers. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E.
  6. Install the front lower air deflector panel. Refer to Radiator Air Baffle and Deflector Replacement - Lower in Engine Cooling.
  7. Lower the vehicle.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26)  or Battery Negative Cable Disconnect/Connect Procedure (LY7) .
scientia non olet · About LEMON Manuals