LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (L26) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Generator & Bolts (3.8L)
    GM302324Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26)  or Battery Negative Cable Disconnect/Connect Procedure (LY7) .
  2. Remove the drive belt from the generator. Refer to Drive Belt Replacement (L26) in Engine Mechanical - 3.8L.
  3. Remove the generator rear brace. Refer to Generator Brace Replacement (L26) .
  4. Remove the bolts (1, 3) and the stud (2) from the generator.
  5. Disconnect the electrical connector from the generator.
  6. Position aside the protective boot from the generator output BAT terminal for access.
  7. Remove the generator output BAT terminal nut and remove the positive battery lead from the generator.
  8. Remove the generator.
scientia non olet · About LEMON Manuals