Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Generator Brace & Retainers (L36)

Courtesy of GENERAL MOTORS CORP.

Install the generator rear brace (4).
Install the generator rear brace bolt (3).
Install the generator rear brace nut (5).

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Tighten the generator bolts in the order described. The following is a mandatory torque sequence:
Tighten:
1. Tighten the generator rear brace bolt (3) to 50 N.m (37 lb ft).
2. Tighten the generator rear brace nut (5) to 50 N.m (37 lb ft).