LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Tray Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Tray & Mounting Bolts
    GM776848Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices
  1. Position the battery tray (2) to the vehicle, locating the alignment datums (1) with the holes in the inner fender.
  2. Install the battery tray bolts to the following:
    • The inner fender panel
    • The shock tower
    • The lower air inlet panel assembly

      Tighten:  Tighten the battery tray bolts to 6 N.m (53 lb in).

    3. Fig 2: Identifying Bolts To Front Air Inlet Panel Assembly To Battery Tray
    GM799787Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 bolts securing the front air inlet panel assembly to the battery tray.

    Tighten:  Tighten the front air inlet panel assembly bolts to 6 N.m (53 lb in).

  4. Install the right air inlet grill panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  5. Install the battery. Refer to Battery Replacement (L26)  or Battery Replacement (LY7) .
scientia non olet · About LEMON Manuals